Skip to main content
Version: 2.6

FANUC Device Skills

Device skills enable special functions within the FANUC driver.

Program Management​

The program management provides functions to download, upload, delete and select Nc programs.

Use the following settings:

{
  "Id": "834276BC-0D04-45D5-AFD2-7A1E07141F99",
  "Name": "ProgramManagement"
}

Direct DNC Transmissions​

The direct DNC transmission allows the Nc controller to request nc programs from HumanOS IoT Gateway.

Use the following settings:

{
  "Id": "5C894A73-D8AB-4C93-B97B-E90B79A34CAE",
  "Name": "DirectDNC"
}

Tool Life Management​

The tool life management allows you to manage the tool life span. Use the following settings:

{
  "Id": "13BB68D0-3B8E-42B9-A5BC-993E5B0D49A8",
  "Name": "ToolLifeManagement"
}

Several access points and functions depend on this capability.

  • Commands
    • clearToolLifeData
  • Access Points (depending memory addresses)
    • Whole range in Nc1.ToolLifeManagement.*
NOTE

The Tool Life Management (TLM) option of FANUC must be also enabled on the FANUC controls.

For addressing the tool life memory, check chapter Tool Life Management Memory.