Skip to main content
Version: 2.7

Connector for Heidenhain Controls

Logo

The HumanOS.UHAL.HeidenhainControl connector allows to integrate HEIDENHAIN CNC Controls into HumanOS®.

Following CNC controls are supported:

  • TNC640
  • iTNC530

Runtimes​

The connector can be used in following HumanOS® Runtimes:

  • Windows x86
  • Windows x64

Connectivity​

HEIDENHAIN CNC Controls are connected via ethernet or serial interface.

NOTE

Option #18 HeidenhainDNC must be enabled in the machine. Key number SIK opens the options. A purchased SIK Key (trial possible) provided by Heidenhain must be entered to enable the option. For trial purposes check the entry Option #18 test version in the SDK Documents.

Configuration​

  1. Installation
  2. Driver Configuration
  3. Data Access
  4. Commands
  5. Alarm Events
  6. Best Practices
  7. Trouble Shooting

Sources​