Connector for Modbus
The HumanOS.UHAL.ModbusTcpControl connector allows to integrate MODBUS based controls into HumanOS®.
Following devices are supported:
- All devices that support modbus TCP/IP communication
- All devices that support modbus RTU communication
Runtimes
The connector can be used in following HumanOS® Runtimes:
- Linux ARM
- Linux x64
- Windows x86
- Windows x64
Connectivity
The connector connects to devices via ethernet (TCP) or serial interface (RTU).
MODBUS TCP
The Modbus TCP Driver needs an Endpoint address (IP), TCP port and a slave Id. See Modbus TCP Connection.
NOTE
The connection is established on TCP Port defined by the device address setting. Make make sure it is open on firewalls and on the device itself.
MODBUS RTU
The Modbus TCP Driver also supports RTU connections. See Modbus RTU Connection to check the connection parameters.